Handheld 4″ Display Tiny Spectrum Analyzer TinySA ULTRA 100kHz to 5.3GHz with 32GB Card Version V0.4.5.1
Official version supports the latest firmware cooperates with ZeenkoFeatures Screen size 4 inch Spectrum Analyzer for 0 1 800MHz or with Ultra mode enabled 0 1MHz 6GHz Signal Generator with sine wave output between 0 1 800MHz or dual tone output up to 4 4GHz when not used as Spectrum Analyzer Switchable resolution bandpass filters for both ranges between 200Hz and 850kHz Built in 20dB optional LNA Color display showing 450 scan points covering up to the full frequency range Input Step attenuator from 0dB to 31dB not in combination with LNA A built in calibration signal generator that is used for automatic self test and low input calibration Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer or Signal Generator Rechargeable battery allowing a minimum of at least 2 hours portable use Max input level 10dBm Do not destroy your tinySA Due to the low cost and very small form factor there are certain relevant tinySA limitations and tinySA Ultra limitations Specification ParameterSpecificationDisplay size4 TFT LCD 480 320 Max low input frequency800MHz 6GHz in Ultra modeResolution filters in 1 3 10 stepsfrom 200Hz to 850kHzMax output frequencySinus up to 800MHzoutput level 104dBm to 16dBmUltra modeLevel calibrated up to 5 3GHzInternal LNA gain20dB up to 4GHzDisplayed points per scanmax 4500 350MHz scan time165msShortest zero span time17msDANL at 100MHz 153dBm Hz LNA Off 169dBm Hz LNA On DANL degrading in ultra mode10dB above 2 5
